Product Features:
●Good adhesion, good two-way affinity to substrates and coatings, avoiding the peeling phenomenon of traditional plastering.
●It has good air permeability to ensure that the wall and paint surface are dry and avoid the paint surface from yellowing, mildew, and paint film foaming and peeling.
●Good construction. A near-perfect smooth surface can be obtained with a simple trowel, reducing paint loss due to uneven substrates.
●Non-toxic, odorless, solvent-free, non-flammable.

Scope of application
●Suitable for cement mortar plastering on interior walls and ceilings of buildings, as the base layer of paint to level and scratch greasy.
●Do not apply directly to non-cement mortar plastering surfaces such as wood and metal. For application on special base surfaces, please consult professional technical engineers.
●Not recommended for substrates and environments with water resistance requirements.

Packaging Specifications
25KG/bag

Base surface treatment:
■ The surface of the substrate should be firm and flat, clean and free from grease, batik and other loose substances. The new plastering base surface should be maintained for at least 14 days before the putty can be scraped. If the base surface is too dry before construction, it should be moistened with water in advance until there is no clear water.

Construction technology:
■ Pour an appropriate amount of water into the container first, then add the powder, and then use an electric mixer to fully stir it into a uniform paste, requiring no powder and no sediment. Let it stand for 3-5 minutes before stirring for a little while. The correct amount of water added and the standard stirring operation are very important to obtain a good construction effect. If you have any questions, please consult our technical engineers.
■ Use batch embedding tools for batch embedding. After about 4 hours after the first layer of batch embedding is completed, the second batch of putty can be embedded and scraped flat. The thickness of each batch of embedding is preferably below 1mm.
■ After the putty layer is inlaid in batches, it can be polished at least 48 hours later.
■ Various paints can be painted 3-4 days after the batch embedding of the putty layer is completed. If an alkali-resistant primer is used, the curing time can be shortened.

Precautions
■ Do not mix the dry paste with water concrete before using it.
■ Do not perform construction outside 5"C-40C or under rain.
■ After the putty layer is completed, it should be polished within 2-3 days.
■ In dry climate, it should be sprayed with water for maintenance.
■ Do not apply TSC1161 indoor water-resistant putty and TSC1162 indoor environment-friendly putty directly on low water absorption base surfaces (such as tiles, mosaics, stones or base surfaces polished with cement paste), or non-cement mortar base surfaces (such as wooden boards, plywood) , gypsum board or metal plate base), to apply putty on special base, please consult our technical engineers.

Health and Safety
■ TSC1161 indoor water-resistant putty and TSC1162 indoor environmental protection putty are alkaline and will irritate the skin. During use, avoid inhalation of dust and contact with skin and eyes, and wear appropriate protective gloves and goggles. Once in contact with skin, rinse with clean water. If contact with eyes, immediately rinse with plenty of water, and seek medical attention as soon as possible. , This product is non-toxic and non-flammable.

storage
■Avoid direct sunlight, and should be stored off the ground on a pallet to prevent rainwater and avoid excessive stacking. If the above method is not stored, it may cause premature failure or agglomeration of the product.

technical parameter